Sticker Application Instructions
All of our Decals are simple "Peel n Stick" type decals. For our
smaller size decals we recommend a dry
application. For our larger Lethal Threat decals, you can use the dry
application or a wet application method.
Below you will find instructions for both types of applications.
Dry
Application
Clean the surface where you will apply the decal. Use window cleaner,
soapy water or rubbing alcohol to
prep the surface, and dry with a lint free cloth. Surface temperature
should be 55F to 70F, and not in direct
sunlight.
With clean dry hands, peel the sticker from the backing card. Try to
handle the decal as little as possible,
only holding by edges.
Line up the sticker how you would like it. Attach the bottom part of
the sticker to the surface, using a
sqeegee or credit card, rub the rest of the decal onto the surface.
If you do have any air bubbles trapped, use a pin to make a small hole
and rub until all bubbles are out.
Wet
Application - Lethal Threat
Decals Only
Clean the surface where you will apply the decal. Use window cleaner,
soapy water or rubbing alcohol to
prep the surface, and dry with a lint free cloth. Surface temperature
should be 55F to 70F, and not in direct
sunlight.
Get a spray bottle, fill with water and add two to three drops of dish
washing detergent, shake bottle to mix
solution. Spray a light mist of the fluid on the desired location where
you will apply the decal.
With clean hands, peel the sticker from the backing paper, do not let
the decal stick to itself.
Position the decal in the misted desired location, using a squeegee or
straight edge, rub the decal from the
center out pushing out any trapped fluid and air bubbles.
For a custom look, some of our customers trim the excess clear border
with a razor blade or X-ACTO knife
and then apply the decal. We do not guarantee your results if you clear
coat over our decals.
|
